RANGE : 165 ft. (50) m to 656 ft. (200 m) outside
RELIABLILITY : Selectable channels, automatic gain control (AGC)
USER-FRIENDLY : Quick and easy installation, elegant design
The UNIRIS II / BIRIS II products are based on PROTECH’s expertise, offering multiple configuration possibilities.
The AGC guarantees detection reliability through 4 selectable channels to prevent interferences between barriers, and guarantee efficient operation of the system.
The UNIRIS II / BIRIS II barriers can be stacked on top of one another offering modularity to adapt to site requirements.
Integrated alignment tools (audible and visual LEDs) make the products easy to install.
UNIRIS II / BIRIS II barriers are designed for both internal and external use in intrusion detection. The applications are diversified: protection of wall-tops, roof-tops, gates, building façades of small industrial sites and private villas.
Custom solutions are also available for specific applications such as roof edges, wall tops, and gates.
UNIRIS II / BIRIS II barriers are designed for internal and external use. The applications are, therefore, diversified: protection of or wall-tops, roof-tops, gates, building façades of small industrial sites and private villas.
Thanks to the modularity, easy and quick installation of UNIRIS II BIRIS II barriers, it is also possible to secure sites with special installation and configuration (for instance, building roofs).
There are also very specific applications such as building façades, roof edges, wall tops, or gates.
|UNIRIS II||BIRIS II|
|Range outside||50m||50m 100m 200m|
|Height of modules||19 cm||35 cm 42 cm 42 cm|
|Number of cells||1 (2 beams)||2 (4 beams)|
|Adjustable cells||Horizontally at +/- 90° and vertically at +/- 10°||Horizontally at +/- 90° and vertically at +/- 10°|
|Source of light||Infrared pulse with a wavelength of 950nm||Infrared pulse with a wavelength of 950nm|
|Alignment Tools||Buzzer, LED||Buzzer, LED, selection switch|
|Power supply||10,5 - 15Vdc||10,5 - 15Vdc|
|Electricity consumption (below 12Vdc)||45 mA - Heater 240mA||80 mA - Heater 340mA|
|Alarm information||Intrusion/ disqualification (Biris II 100 and 200)/tamper||Intrusion/ disqualification (Biris II 100 and 200)/tamper|
|Operating Temperature||-35°C to +70°C||-35°C to +70°C|
Barriers must be installed on a stable support. Check that ground is level to ensure stability of the sensors over time.
A maximum of 10° elevation may be tolerated between the columns. In case of elevation above 10°, contact PROTECH’s sales department.
Beams must be free of vegetation coverage regardless of the season and weather condition (wind).
This technology works at a wavelength above that of visible light (950nm), which makes the IR beam invisible to the naked eye.
The infrared beams are transmitted and received by infrared cells. The transmitter cellsgenerate a pulsed beam that is sent towards the receiver cellswhich capture the infrared pulses and transform them into electrical signals. In the absence or variation of the signal (loss of 95% of the transmitted signal), an intrusion alarm is triggered. To prevent the receiver cells from being interfered with by the transmitted infrared beams thecells are multiplexed.
This principle consists in transmitting an infrared pulse in a synchronised manner, via an optical or wired link between the transmitter and receiver columns. This feature is also used to optimize the alignment of the cells (“alignment feedback”). All the SORHEA IR barriers are multiplexed (except UNIRIS II & BIRIS II).